Five points that must be paid attention to when using the heat press machine
The types of heat transfer films are increasing day by day, and the heat transfer machines that follow are also overgrown with weeds! We need to choose different heat press machines according to different material environments. As soon as there are more machines, problems arise accordingly. Therefore, you need to pay attention to the following points when thermal transfer processing!
1. Keep the machine clean: keep the important parts of the machine clean, not stained with oil and dust, keep the thermal transfer film clean, not stained with fingerprints and dust, keep the printing products clean, free of dust, oil, and keep the hands of the processor clean , No oil stains, no sweat.
Second, the hot stamping pressure: the hot stamping pressure must be adjusted to the most appropriate, otherwise it is easy to damage the rubber head and the object to be hot, and if it is too small, it will affect the hot stamping effect. After adjusting to the best hot stamping pressure, the pressure should be adjusted and locked to avoid changes in mass production.
3. Hot stamping temperature: Hot stamping temperature has a significant impact on the quality of thermal transfer products. If the hot stamping temperature is too high, the substrate may be damaged. If the hot stamping temperature is too low, normal transfer may not be achieved. The ironing temperature should be determined by factors such as the substrate, the flower film, and the heat transfer machine. Different materials have different ironing temperatures.
4. Hot stamping speed: The hot stamping time (speed) should be determined according to the specific hot stamping material. In the case of ensuring the hot stamping effect, the faster the speed, the higher the production efficiency, but some products must be limited by some special conditions. Use slow hot stamping.
5. Please use the plug-in board matched with the heat press machine. Although other power strips are available, the corresponding voltages are different, so the power strips should not be used indiscriminately.